Home > News > Content
Laser Engraving Machine Settings
- Mar 02, 2016 -

* Carved lattice sculpting high resolution dot matrix-like dot-matrix printing. Laser head side to side, each carved out a section consists of a series of points of a line, and then laser head moves up and down simultaneously engraved lines, and finally forms an integral version of the image or text. Scanned graphics, text and vector graphics can use dot matrix carving.

Cutting and carving different dot-matrix * vector, vector cutting is carried out on the outer contour of the graphic. We usually use this pattern in wood, acrylic, paper and other materials for penetrating cut, also available in a variety of materials surface marking operation.

* Carving speed: engraving speed refers to the speed of the laser head moving, often using IPS (inches per second), high speed and high efficiency. Speed is also used to control the depth of cut, for a particular intensity, more slowly, cutting or engraving, the greater the depth. You can use engraving machine Panel to adjust speed, computer software could also be used to adjust the speed. In the range 1% to 100%, adjustment is 1%. Motor enables advanced motion control system in high-speed carving, you still get super fine engraving quality.

* Sculpture strength: sculpture pointing to strength to strength of materials by laser. For specific engraving speed, the greater the intensity, greater depth of cutting or engraving. You can use the engraving machine Panel strength, computer software could also be used to adjust the intensity. In the range 1% to 100%, adjustment is 1%. The greater the intensity or speed are smaller. Cutting depth is deep.

* Spot size: laser beam spot size can be adjusted using different focal length lenses. Small spot of lenses for high-resolution engraving. Engraving of the great spot lens for low resolution, but for vector cutting, it is the best choice.